Drawing die is an important part of the wire drawing machine. In the process of drawing, we not only need to ensure high-quality wire but also need to effectively control the cost of the die. Cemented carbide wire tool is the trump product of UKO and one of the first batch of UKO products facing the market. In the use of carbide wire drawing die, UKO to share a few points for attention.
1. Ensure the smooth operation of wire drawing equipment: each wire guide dies shall be smooth and flexible, and the run-out tolerance shall be strictly controlled. If the drum, guide dies wear groove, should be repaired in time. UKO can also customize wire guide dies of cemented carbide or high-speed steel for customers. For its quality and tolerance, we have a strict quality inspection to ensure the smooth operation of customer equipment.
2. Good lubrication condition is an important condition to ensure the surface quality of the wire rod and prolong the service life of the die. The lubrication index should be checked frequently, and the copper powder and impurities in the lubricating oil should be removed so as not to pollute the equipment and die hole. If the lubrication fails, the lubrication system must be replaced and cleaned in time. UKO has close cooperation with our drawing powder manufacturers. According to UKO products for the wire industry, as well as customer demand, we have made many kinds of wire drawing lubricant powder. To provide customers with low-cost high-quality drawing powder.
3. Reasonable die matching to ensure the surface quality of wire rod, accurate and consistent size control, reduce the wear of wire drawing drum and reduce the running load of equipment. For the sliding wire drawing machine, it is the first step to be familiar with the mechanical elongation of the equipment and reasonably select the sliding coefficient. UKO provides customers with considerate after-sales service and technical support. When you encounter relevant problems in use, you can contact our after-sales personnel at any time.
4. Select the dying pass according to the material of the material to be drawn and the reduction rate of each drawing. Generally speaking, the harder the wire is, the smaller the compression angle of the die is, and the longer the sizing zone is; vice versa. The reduction rate of each drawing is also closely related to the compression angle of the corresponding die, so the compression angle should be adjusted according to the reduction rate. UKO provides customized service for customers to ensure all sizes and special shape requirements of customers. At the same time, we can also provide customers with PCD drawings dies to meet the diversified needs of customers.